I confirmed diagnosis and replaced harness and ran unit through rinse and spin then smart insall mode to verify no new error codes were present and unit is testing ok to factory specs

"Issue unit wont run. Found no iss with any of the safeties, no issue with supply voltage. Found that motor relay on board isnt closing causing issue.

"I confirmed diagnosis and replaced MEMS sensor and ran unit through spin cycle and unit completed with no further issues

"I confirmed diagnosis and replaced MEMS sensor and ran unit through spin cycle and unit completed with no further issues

"Cx concerns are unit keeps filling and draining without spinning, I put unit into diagnostic mode and checked error codes and found 8c2(MEMS PBA error) this error pertains to unit not being able to sense when basket is in motion, I checked that all connections are seated properly, unit was able to spin and agitate during automatic test cycle and based on technical information I determined unit needs new mems sensor ordrng 1 DC93-00278B (Mems sensor)"