ran in diag and no components activated / removed panel and tested resistance at drain pump harness / all windings are in spec / found incorrect voltage from main PCB / need to order and replace main control board / no other defects ordrng 1 EBR86498802 (PCB assembly)

"Replaced drain hose and ran unit through test cycle to verify repair and found no leaking to trigger foloat switch. Unit tested ok to factory specs

"Cx concerns are unit constantly fills and had to turn off unit at breaker, found that unit is constantly draining and will not respond to any keys being pressed, pulled unit out and found water in float switch basin, cleared out water and ran unit to see if there is any active leaking, could not find any active leaking under dishwasher but drain line has a giant hole in it, ordrng 1 00744881 (Drain hose)"

Cx concerns unit doesnt work. Water valve was shutoff by plumber did not open again. Tested unit. Runs and drains fine no leaks. Runs to specs

"Issue when unit will cycle heat it never turns back on. No issue with gas pressure at 8inH2O, set to a 350 bake and temp reached 430 without cycling. Spoke with Bobby from tech line; states that the temp probe on valve is faulty and need to be replaced. ; ordrng 1 503136 (Thermostat)"