Installed new control board and ran. Unit is heating to specs.

Removed part from dryer. Giving back to office.; snapped 1 QuickPics

Cx concerns are unit has F1. Unit has a primary control failure. I unplugged to reset same code. ; ordrng 1 WPW10141671 (Control board)

"I confirmed diagnosis and replaced igniter and ran dryer on time dry high heat with vent unattached amd unit cycled at ~130? F and tested ok to factory specs, I advised cx if issue is persistent to have vents looked at"

"Cx concerns are unit is still not heating properly. First I tested vent and got .55in/wc before booster fan and .35in/wc after booster fan but while unit is running cold air is being pushed back into unit from booster fan ordrng 1 279322 (Dryer igniter)"