Rechecked sensors. No issue with sensors. Replaced control board. No further issue with unit at the moment.

"Couldnt replace door assembly, took hinges from the old door and put them on the new door because new hinges were closed

"Issue unit isnt cooling, and display isnt wshowing temp or working properly. display is showing L and unit isnt cooling, compressor pulling .3amps; states that the display is faulty, and unit has a faulty sealed system. unit will need a compressor and filter drier as well as the display board.

"Issue larger oven isnt heating properly, taking to long to pre heat. Found no issue with elements of unit. Advised that the relay board will need to be replaced or sent to be refurbished, and that door isnt closing properly due to faulty door latch either stuck in the locked position or not fully opened.

Issue unit isnt cooling. Display is showing proper temp of 70. When testing the voltage to the compressor, compressor turned on pulling .7amps, no issue with supply or amps. Temp dropped ten degrees and theres an even frost pattern on evap.