Installed new main PCB assy and tested / drain pump is struggling to spin its slowly turning 2 tested voltage out of PCB is correct / need to order drain pump and return to complete this repair / drain pump tested in spec last time I was here / ; ordrng 1 AHA75673404 (Drain pump assy)

ran in diag and no components activated / removed panel and tested resistance at drain pump harness / all windings are in spec / found incorrect voltage from main PCB / need to order and replace main control board / no other defects ordrng 1 EBR86498802 (PCB assembly)

"Replaced drain hose and ran unit through test cycle to verify repair and found no leaking to trigger foloat switch. Unit tested ok to factory specs

"Cx concerns are unit constantly fills and had to turn off unit at breaker, found that unit is constantly draining and will not respond to any keys being pressed, pulled unit out and found water in float switch basin, cleared out water and ran unit to see if there is any active leaking, could not find any active leaking under dishwasher but drain line has a giant hole in it, ordrng 1 00744881 (Drain hose)"

Cx concerns unit doesnt work. Water valve was shutoff by plumber did not open again. Tested unit. Runs and drains fine no leaks. Runs to specs